Please log in. To create a new account, enter the name and password you want to use.
If you supplied an email address when you signed up or added a email later, you can have your password reset.
This user name doesn't exist. If you want to create a new account, just verify your password and log in.
This user name exists. If you want to create a new account, please choose a different name.
Enter the current email address you have registered in your profile. You'll get an email containing your new password.
You have no email address in your profile, so you can't have your password reset.
Password reset. Check your email in a few minutes
That account does not exist.
The email address specified is not registered with this account.
Delivery to this email address has failed.
10->All filters off, scanner sensors set to full range at 600dpi/24bit 20->noise ninja (just make sure at least no noise is amplified--this occassionally appears with bad noise profiling), save this. 30->smart blur, while preserving as much detail as possible to eliminate local color variations. 40->Dust&scratches at 1px 1 or 2 passes, to eliminate dots mistakenly left out by the step above. 50->Inspect the document and see if I have lost too much detail-- if yes, back to 30 and use a milder setting. 60->Remove crease and other artifacts--I do this last because scanning moire sometimes prevent me from correctly determining colors. 70->See if there are portions where I want detail over low noise, load the mid-product saved in 20 and replace them. 80->adjust the colors, trim out borders, correct roll error. 90->resize to 300 dpi.save.
kiowa
This method is largely based on this one:
http://www.pireze.org/blog/?p=250
10->All filters off, scanner sensors set to full range at 600dpi/24bit
20->noise ninja (just make sure at least no noise is amplified--this occassionally appears with bad noise profiling), save this.
30->smart blur, while preserving as much detail as possible to eliminate local color variations.
40->Dust&scratches at 1px 1 or 2 passes, to eliminate dots mistakenly left out by the step above.
50->Inspect the document and see if I have lost too much detail-- if yes, back to 30 and use a milder setting.
60->Remove crease and other artifacts--I do this last because scanning moire sometimes prevent me from correctly determining colors.
70->See if there are portions where I want detail over low noise, load the mid-product saved in 20 and replace them.
80->adjust the colors, trim out borders, correct roll error.
90->resize to 300 dpi.save.
also, apology for my poor english ^^